[Orca-users] Re: gigswift support

[Blair Zajac]

orcausers wrote:
> 
> sorry - i meant the newest orcallator.se file - 1.35 - .

No, you shouldn't need that.  Just the latest orcallator.cfg file.

Best,
Blair

> 
> --- In orca-users at y..., Blair Zajac <blair at o...> wrote:
> > orcausers wrote:
> > >
> > > curently running orca o.26beta1 - sorry dont know .cfg level -
> > > and setoolkit 3.2 with 1.25 se file.
> > >
> > > i need to upgrade to cfg 1.35 to get gig support - do i have to
> > > upgrade to se 1.35 at the same time?
> >
> > There is no SE 1.35.  You mean orcallator?  No, older versions
> should
> > pick up the card.  However, check the output data files from your
> > orcallator.se just to make sure the data is being measured.  If not,
> > then I would upgrade.
> >
> > >
> > > do i have to upgrade to setoolkit 3.3 also?
> > > and  to orca 0.264 ?
> >
> > No.  You should not need to.
> >
> > >
> > > and do i have to do all the domains at once if i upgrade orca to
> cfg
> > > 1.35 to get the gig support - i don't have these gig cards on all
> the
> > > domains but i think in previous conversation - it was all had to
> go
> > > at once.
> >
> > No, you just need to upgrade the orcallator.cfg file on the system
> that
> > runs Orca (you should only have one system running Orca).
> >
> > Best,
> > Blair