[Orca-users] installation problems ...

[Peter Ryall]

hi blair and all,

all i did was to do what leo suggested (remove (actually) one
line from configure and did):

# configure
<snip>
# make
<snip>
# make install
<snip>

(like it says in the README) in the packages/rrdtool... directory.

then i did the configure, make and make install in /tmp/orca-0.27
directory.

regards,

peter r.

--------------------------------------------------------------------------
Security Statement

The information contained in this electronic mail message is
privileged and confidential, and is intended only for use of
the addressee. If you are not the intended recipient, you are
hereby notified that any disclosure, reproduction, distribution
or other use of this communication is strictly prohibited.
Confidentiality and legal privilege attached to this communication
are not waived or lost by reason of mistaken delivery to you.
If you have received this communication in error, please notify
the sender by reply transmission and delete the message without
copying or disclosing it.

Disclaimer

Any views expressed in this communication are those of the
individual sender, except where the sender specifically states them
to be the view of NSW Businesslink Pty. Ltd.  Except as required by
law, NSW Businesslink Pty. Ltd. does not represent, warrant and/or
guarantee that the integrity of this communication has been
maintained nor that the communication is free of errors, virus,
interception, inference or interference.
--------------------------------------------------------------------------