[Orca-users] Re: Newbie compile problems

[Blair Zajac]

The pod2man program comes with Perl.  Make sure it is installed and
this step of the Orca install should pass without any issues.

Regards,
Blair

Chris Hermosillo wrote:
> 
> After running the configure for orca, I attempt to perform the initial
> make and this is what I get.  I have looked through compile error
> emails and found one similar (#253), but that was for an older version
> which has now been corrected.  I am using orca-0.26.  Any help you can
> provide would be much appreciated.
> 
> cd packages && make CFLAGS=-g
> cd rrdtool-1.0.13 && make CFLAGS="-g"
> Making all in cgilib-0.4
> Making all in config
> Making all in gd1.3
> Making all in zlib-1.1.3
> Making all in libpng-1.0.3
> Making all in src
> Making all in doc
> pod2man --release=1.0.13 --center=rrdtool rrdtool.pod  > rrdtool.1
> sh: pod2man: not found
> *** Error code 1
> make: Fatal error: Command failed for target `rrdtool.1'
> Current working directory /opt/orca-0.26/packages/rrdtool-1.0.13/doc
> *** Error code 1
> make: Fatal error: Command failed for target `all-recursive'
> Current working directory /opt/orca-0.26/packages/rrdtool-1.0.13
> *** Error code 1
> make: Fatal error: Command failed for target `make_rrdtool'
> Current working directory /opt/orca-0.26/packages
> *** Error code 1
> make: Fatal error: Command failed for target `all'
> 
> 
> --
> Chris H.
> 
> 
>                       eGroups Sponsor
>